Aemit released VCO II (for Eurorack)

Aemit released VCO II, a 3340 based analog VCO for Eurorack

Features :

• 3340 based analog VCO
• Original vintage 1982 design adapted to Eurorack
• Audio range : 5Hz – 22 kHz (@ 12V input, absolute max is 40 kHz).
• Low range : 45 sec. – 100 Hz (@ 12V input, absolute max is 170 Hz).
• 1V/octave over 12 octaves (5Hz to 20kHz).
• Linear FM input.
• Precise control : 3 FM inputs and attenuators, 1 is bipolar, 1 is linear.
• Span lower sets coarse pot for lowest 6 octaves, span upper sets coarse pot for highest 6 octaves, with an overlap of 1/2 octave.
• Fine tune.
• Pulse Width adjustable from 5 to 95%, PWM with input jack and attenuator.
• PW affects Pulse and “Pulsaw” outputs.
• Individual outputs : rising and falling sawtooth, “pulsaw”, pulse, triangle and sine, low impedance, 10 Vpp.
• Soft and hard sync.
• Skiff friendly : 35mm deep behind front panel (overall depth including front panel and knobs is 55mm).
• Shrouded header on the power supply connector, no risk for reverse polarity.
• Includes printed manual card and power cable.
• Disclaimer : despite info on the right of this page, this module is currently only available on direct order at Aemit.

VCO II is available for €199 here: https://www.facebook.com/aemit17/