9. July 2016 | Free Software | Carl
Trans Computer Maschine v2.3 – Cescato Musiktechnologie – for free
Cescato Musiktechnologie has released a new beta version 2.3 of Trans Computer Maschine. The tool consists of oscillators, LFOs and a sequencer gate. For downloading the tool you just need to like it on Facebook.
Check these out!
Leave a Reply
You must be logged in to post a comment.
This site uses Akismet to reduce spam. Learn how your comment data is processed.
– Added double triggered ‘Seq Gate’ to Envelopes gate sources.
– Added ‘KBD Gate’ to Envelopes auto-enabled when sequencer is not started.
– Added ‘LFO’ activity indicator.
– Added ‘Lower’ range extender to Oscillators frequency modulation sources.
– Added Oscillators patch change ‘KBD Memory’ enabler/disabler.
– Added Patch selection GUI controls.
– Added selection displays for expanded ‘Filter’ modulation destinations.
– Fixed at last un-synced ‘LFO’ frequency messed up after patch change.
– Fixed Oscillators ‘Low F’ switches not working with ‘Seq In’ enabled.
– Fixed Sequencer active ‘LED’ shift after it was stopped.
– Fixed Sequencer reset shift in ‘Pendulum’ modes.
– Fixed Sequencer ‘Set’ buttons shift when gating via Synth Channel.
– Fixed Sequencer ‘Sync’ altering ‘Tempo’ setting after patch change.
– Fixed/changed S/H Mixer behaviour for ‘Expand’ sources.
– Improved (further) ‘LFO’ phase-alignment with sequencer stepping.
– Improved modulation at audio rates.
– Improved ‘Noise Colour’ modulation and added S/H signal source.
– Improved Sequencer sync for varying tempo use.
– Improved stepped response for ‘Interval’ and ‘Transpose’ Sequencer knobs.
– Renamed some parameters and updated GUI.
– Replaced Sequencer ‘Transpose’ values with selectable octave ranges.
– Revised and optimized code.